to scarp curved surfaces the scraper is :=
A- bull nose scraper B- half round scraper C- triangular scraper D- two handle scraper
- Khon
- 27 दिसम्बर
- 14 उत्तर
14 उत्तर
14 उत्तर
-
B0Modal content
-
?0Modal content
-
half round scraper0Modal content
-
a1Modal content
-
A . big curved surface ko scrap kerne ke leye bull nose scrapper ka use keya jayega.and scrap the bearing surface to half round scrapper.0Modal content
-
C0Modal content
-
b1Modal content
-
b-1Modal content
-
B.Half Round File-1Modal content
-
B1Modal content
-
b-1Modal content
-
b-1Modal content
-
B7Modal content
- gyan
- abhishek
- onkar
- akash
- rahul
- ankit
- akshay
- gyan
- abhishek
- onkar
- akash
- rahul
- ankit
- akshay
- No Down Vote
View all vote's
अन्य संबंधित चर्चाएं
-
swg ka paras kitna hota hai
-
लैपिंग का प्रयोग _______के लिए किया जाता है? A. केवल अधातुएँ b. केवल धातुओ c. धातुओ एव अधातुओं d. न ही धातुओ न ही अधातुओं
-
which ratio of mendral A. 1:200 B.200:1 C. 1:2000 D. 2000:1
-
Honnig me kitna allowance hota hai
-
What are the upper and lower Deviation of basic hole and basic shaft. 1.min.max 2.min.min 3.Zero.zero 4.max.max
-
टिवस्ट ड्रिल को धातु के अंदर जाने में सहायता प्रदान करता ह
-
The quick releasing taper angle is not less than......
-
prik punch ka angle kitna hota hai.. book mein 60 de rakha hai.. or sir kehe rahe thy ki..30 hota h..
-
Ek 3 phase 400 v ke induction motar ka torque 100 Nm hai. Jab supply voltage kam krke 300 v krne pr torque kitna hoga? (plz explain this qus) 1)50Nm 2)56.25Nm 3)75Nm 4)150Nm
-
HMC ka full from kya hoga
