Close sidebar

How to design Electronics devices ?

Electronics devices tips

  • Shreya
  • 2603 Views
  • 5 Answers
  Answer
5 Answers

  • The five steps for the development of an electronic product are:br /Step #1 – Design the Circuit Schematicbr /Step #2 – Design the Printed Circuit Board (PCB) Layoutbr /Step #3 – Evaluate and Debug the Prototypebr /Step #4 – Program the Microcontrollerbr /Step #5 – 3D Modeling

    0

  • If you just want one or two and don't plan on selling them, the easiest way is to roll up your sleeves, break out the soldering iron and make it yourself! (Or find someone with a maker-mentality that would be willing to make it for you as a personal project). This is a project that is at the level of most hobbyists.  Make sure you start with a regulatory approved power supply for safety reasons, and then regulate out the power from there (one voltage regulator per connected device) and connect to the right connectors and cables.br /br /(EDIT): Note that if you really want it to be as small and lightweight as a typical _travel_ adapter, that is not a task for an amateur. You are trying to supply a lot of power to charge that many devices, and will likely end up with something about the size of a laptop brick to handle the power requirements and safely dissipate the heat generated by the regulators.

    0

  • For designing an Electronics device, firstly you should be clear with your idea regarding what purpose the device is for, how to make it work. Plan it out and daraw figures if required. Mainly draw the electronic circuit  schmatically, which is to be used. make all the aparatus available with you. Also design the 3D look of your device and orthograpic projection if required.Accordingly make the circuit as in the diagram. Be careful while doing the connections.Make Program for your devices (Microcontroller) which will make it do the particular work. Check and debug your program.Upload the data (program) to the components like ardieuno or motor driver or bluetooth chip etc.design your electronic device model. Try to make it convenient, eco friendly. It should also be resistive durable.Fit in your circuit in the 3D model. Make the device completely ready and then have trails of working and if present remove the bugs.

    0

  • Not electronic device mam electronic circuit

    0
  Other Related Discussions
Ask a Question
Practice Mock Test
electronic devices
Youth4work © 2024