a fixture does not - a)hold the workpiece b)locate the workpiece c)guide the tool d)all of these

Dinesh

• Dinesh
• 2258 Views
• 7 Answers

• c

  • Kaibalya
  • 15 Nov
  • 0 Comment

  0

  ---

• d

  • S.Manikandan
  • 30 Jul
  • 0 Comment

  0

  ---

• c

  • Naresh
  • 30 Jul
  • 0 Comment

  0

  ---

• c

  • Subhakanta
  • 30 Jul
  • 0 Comment

  0

  ---

• D

  • Vaibhav
  • 20 Jul
  • 0 Comment

  2

  ---

• c

  • Dinesh
  • 19 Jul
  • 0 Comment

  -1

  ---

• enjoy new website
• what is a HRCF?
• When testing the diodes is the bridge rectifer used in the battery charger one of the diode in the defective. What will be the DC output voltage?
• A sine bar is used to measure... A-surfase roughness B-gear profiles C-internal taper D-external taper
• When the lead-acid cell is fully charged the electrolyte assumes --------- appearance.
• For general purpose , a bench vice is fixed at a height of a) 80cm b) 90cm c) 106cm d) 125cm
• vernier caliper least count
• when tolerance given in one side of the basic dimension,it is called? a)tolerance system b)unilateral tolerance c)Bilateral tolerance d)Allowance system
• what is ohms law
• transistor terminal