2 Answers
2 Answers
-
kahi mahit nahi1Modal content
View all vote's
Other Related Discussions
-
the relieve angle given behind the cutting edge is called.
-
A cutting tool use to cut outside thread is called
-
4
-
petrol engine idling compression ratio
-
The inside caliper is used for to measure the
-
Angle of V groove of Universal surface gauge
-
what is the value of power if the resistor of 1500 chms draw a current of 0.08 amps?
-
which current in janret in DC janretor
-
Boiling point of water
-
when tolerance given in one side of the basic dimension,it is called? a)tolerance system b)unilateral tolerance c)Bilateral tolerance d)Allowance system
