7 Answers
7 Answers
-
measured the critical slot dimensions0Modal content
-
check the angle0Modal content
-
Slip guages are universily accepted standards They can be used to measure tolerances in the range of 0.001 to 0.0005 mm very accurately.0Modal content
-
it is used as a reference for the calibration of measuring equipment used in machine shops, such as micrometers, sine bars, calipers, and dial indicators1Modal content
-
taper angle and bore0Modal content
-
steel0Modal content
-
taper and Angle checked0Modal content
View all vote's
Other Related Discussions
-
The temp indicating instruments in a vehicle indicates the temperature of_______
-
Center punch angle is?
-
how to read matrix scale
-
what is the value of power if the resistor of 1500 chms draw a current of 0.08 amps?
-
Q.shaded pole motaor has........ A)low starting torque B)poor PF C)Large slip D)All of these
-
which material used for makin permanent magnet in PMMC
-
1inch=
-
1. If two meters X and Y requires 40mA and 50mA respectively, to give full scale deflection, then: a) X is more sensitive b) Y is more sensitive c) Both X and Y are equally sensitive d) It would not b
-
The underground cable is protected by:- 1)M.S. and Cement pipe 2) Granite stones 3) Layer of sand bricks 4) Layer of stones
-
how many types of capacitor is used in electric field
